Oricom 870 User Manual page 38

38 38 Help and troubleshooting
My Parent/Baby unit isn't working. What should
I do?
Check that:
1. power cables are plugged in and switched on at the
wall socket
2. batteries are installed correctly and fully charged
3. the units are turned on
4. the Parent unit isn't too far from the Baby unit(s)
(large obstructions or other electrical devices might
affect the signal between the Parent and Baby
unit).
Sometimes unplugging the power cables, waiting
about 20 seconds, and then plugging them back in
can help. If you do this, you'll need to allow about a
minute for Parent and Baby unit(s) to link.
My Parent/Baby unit is making a high-pitched
noise.
What should I do?
They might be too close together. Make sure they're
at least 2-3 metres apart.
How do I reset my Parent unit?
In Menu, tap Oricom Help then tap Factory Reset.
Need some help? Call 1300 889 785 or go to www.oricom.com.au
How do I reset my Baby unit?
Within three seconds of the Baby unit starting, press
and hold down the and
seconds.
Why is my Parent unit beeping?
The Parent unit beeps when:
• your units aren't linking – see page 9.
• there's a problem with mains or battery power
• a cry alert is switched on – see page 31.
How do I pair the Parent unit to a camera?
• select the camera menu
• select which camera you need to pair
• the on-screen instruction will ask you to turn on the
camera and press and hold down the night light
button.
buttons for about five