Operating Mode; Safety Devices; The Cup-Warmer; Dose Programming Phases - Rancilio classe 10 Technical Manual

5.2

Operating Mode

Once the temperature/pressure has been reached,
current date/time or pressure is displayed (for 20
sec.) alternatively to two logo (10 sec. each, to be
personalized).
During dispensing, the following is displayed:
If one of the two time control functions is activated,
instead of the coffee symbol the following is shown
in sequence:
- The GrX (X= n. activated group) flashing throu-
ghout the dispensing period
- The dispensing time in the row under GrX for 10
seconds at the end of dispensing
5.3

Safety Devices

5.3.1 If the safety device concerning the boiler
water level intervenes, the following message is
displayed:
" water missing "
5.3.2 If the safety device concerning the fact that the
heating time is greater than the set one, the following
message is displayed:
"pressure low"
5.3.3 If the safety device for slow dispensing inter-
venes, the LED of the dispensing button must flash
until the end of dispensing.
The boiler safety devices can be reset by switching
the machine OFF and then back ON again
5.4

The Cup-Warmer

By pressing the relative button, the display shows
the following:
Depending on the darkened segments it indicates the
selected power status of the cup-warmer resistances
(min – med – max – off).
The passage from one level to the next is explained
in the relative chapter (5.2.1).
50
5.5 Dose programming phase
During this phase, the "Dose programmation" will
be flashing.

6. LIST OF MALFUNCTIONS

G00 = CPU check
G01 = Water missing
G02 = Pressure low
G03 = Boiler probe short-circuited
G04 = Boiler probe cut off
G05 = Connection IDS
G06 = No resin reconditioning
G07 = No maintenance
G08 = Coffee washing cut off
G09 = TSC washing cut off