Making Coffee; Dispensing Steam With The Tsc System; Renewal The Millk Nozzle; Button Panels - Rancilio classe 10 Technical Manual

1.

MAKING COFFEE

1.1 Number of Dispensers
The coffee maker is equipped with 4 coffee dispen-
sers with programmable dose and pre-brewing cycle
time.
1.2 Operating Cycle
When one of the coffee buttons is pressed for one of
the 4 dispensers, the following occurs:
- The dispensing solenoid valves are energized
and the pump motor starts for a time that can be
programmed between 0 and 5 sec
- The dispensing solenoid valves are de-energized
and the pump motor stops for a time that can be
programmed between 0 and 5 sec
- The dispensing solenoid valves are energized
and the pump motor starts until the programmed
impulses are reached, which start decreasing
during the first phase.
PICCOLO
SMALL
PETIT
KLEIN
PEQUEÑO
PEQUENO
2. DISPENSING STEAM WITH THE TSC
SYSTEM
To use this function, press the specific buttons on the
button panel; it is automatically stopped when the set
temperature is reached.
Safety Devices
No steam can be dispensed if the machine has not
reached the operating pressure or temperature at
least once.
Steam dispensing is discontinued automatically after
3 minutes if the set temperature has not yet been
reached.
40
MEDIO
MEAN
MOYEN
DURCHSCHNITTLICH
MALO
MÉDIO

2.1 Renewal the millk nozzle

To increase or decrease the quantity of whipped
milk change the standard medium whipping nozzle
(identified by one notch) by removing it as shown in
the figure.
 Install the large nozzle (identified by 2 notches) to
increase the quantity of whipped milk.
 Install the small nozzle (no notch) to decrease the
quantity of whipped milk.
3.

BUTTON PANELS

3.1 Coffee Button Panel

This panel features 5 buttons for each di-
spenser (max 4) and 5 LEDs consisting of
the following:
4 buttons for start/stop dispensing
the programmed coffee dose (A-B-C-D)
1 button (E) for:
- Stop dispensing any dose
- Start in continuous mode
- Initialize dose programming for
self-learning if pressed for about 8 sec.
(If the function is enabled)
Each time a coffee is dispensed, the LED of
the relative button lights up.
During dose programming, the LED of the
stop button flashes.

3.2 Function and Hot Water Panel

This panel features 5 buttons and 5 LEDs
consisting of the following:
GRANDE
GREAT
1 cup-warmer button (F)
GRAND
2 buttons for dispensing hot water
GROSS
GRANDE
(G-H)
GRANDE
1 steam-dispensing button with
temperature control (I)
1 steam delivery with temperature and emulsion
control (L)