Connecting The Wire To The Headlight - Toro Power Max 926 OXE Operator's Manual

1. Short rod
4. Insert the front end of the rod into the opening in
the back of the chute gear cover until it slides into
the chute gear (Figure 16).
5. Align the holes in the nested ends of the rods and
insert 2 carriage bolts (in the loose parts bag) through
the short rod from the left side of the machine (from
the operating position).
6. Insert the cable clip that supports the deflector
cable onto the forward carriage bolt, and secure the
carriage bolts with locknuts from the loose parts bag
(Figure 17).
Figure 15
2. Long chute control rod
Figure 16
1. Cable clip
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
5
Connecting the Wire to the
Headlight
Parts needed for this procedure:
1 Cable tie
Procedure
1. Insert the wire connector on the loose end of the
wire straight into the back of the headlight until it is
securely in place (Figure 18).
1
G016761
1. Plastic clip on wire
connector
2. U-bolt
11
Figure 17
2. Deflector cable
2
Figure 18
3. Cable tie
3