Operating The Quick Stick; Operating The Auger/Impeller Drive - Toro Power Max 926 OXE Operator's Manual

Operating the Auger/Impeller
Drive
1. To engage the auger/ impeller drive, squeeze the
right hand (auger/ impeller) lever to the handgrip
(Figure 38).
2. To stop the auger and impeller, release the right hand
lever.
Important: When you engage both the
auger/impeller lever and the traction lever, the
traction lever locks the auger/impeller lever
down, freeing your right hand. To release both
levers, simply release the left hand (traction)
lever.
3. If the auger and impeller continue to rotate when
you release the auger/impeller lever, do not operate
the machine. Check the auger/impeller cable (refer
to Checking and Adjusting the Auger/Impeller
Cable) and adjust it if necessary. Otherwise, take the
machine to an Authorized Dealer for service.
WARNING
If the auger and impeller continue to rotate
when you release the auger/impeller lever, you
could seriously injure yourself or others.
Do not operate the machine. Take it to an
Authorized Service Dealer for service.
Figure 37
Figure 38
Operating the Quick Stick®
Hold the blue trigger cap down to use the Quick Stick
to move the discharge chute and the chute deflector.
Release the trigger cap to lock the discharge chute and
chute deflector into position (Figure 39).
Moving the Discharge Chute
Hold the blue trigger cap down and move the Quick
Stick to the left to move the discharge chute to the left;
move the Quick Stick to the right to move the discharge
chute to the right (Figure 40).
• If the chute does not move, refer to Adjusting the
Discharge Chute Latch.
• If the chute does not turn as far to the left as it does
to the right, ensure that the cable is routed to the
inside of the handles. Refer to Installing the Upper
Handle.
• If the chute does not lock into place when you release
the trigger cap, refer to Adjusting the Discharge
Chute Latch.
19
Figure 39
Figure 40