Stopping The Engine - Toro Power Max 926 OXE Operator's Manual

3
Figure 31
1. Electric-starter button
2. Electric starter plug-in
Note: To use the electric starter, connect a power
cord to the electric starter plug-in first and then
to a power outlet. Use only a UL-listed, 16-gauge
extension cord recommended for outdoor use that
is not longer than 50 feet (15 m).
WARNING
The electrical cord can become damaged,
causing a shock or fire.
Thoroughly inspect the electrical cord before
using the machine. If the cord is damaged,
do not operate the machine. Replace or repair
the damaged cord immediately. Contact an
Authorized Service Dealer for assistance.
Important: To prevent damaging the electric
starter, run it in short cycles (5 seconds on,
5 seconds off), no more than 10 times. If the
engine still does not start, take the machine to
an Authorized Service Dealer for service.
8. Disconnect the power cord from the power outlet
first and then from the machine (electric start only).
9. Allow the engine to warm up; gradually move the
choke toward the Run position. Wait for the engine
to run smoothly before each choke adjustment.
CAUTION
If you leave the machine plugged into a power
outlet, someone can inadvertently start the
machine and injure people or damage property.
Unplug the power cord whenever you are not
starting the machine.
1
2
G016508
3. Recoil starter

Stopping the Engine

1. Move the throttle to the Slow position, and then to
the Stop position (Figure 32) to kill the engine. The
engine can also be stopped by pulling the ignition
key outward to the middle position.
2. Wait for all moving parts to stop before leaving the
operating position.
3. Remove the ignition key to prevent accidental
starting.
4. Close the fuel shutoff valve by rotating it clockwise
(Figure 33).
5. Pull the recoil starter 3 or 4 times. This helps prevent
the recoil starter from freezing up.
17
G016505
Figure 32
G016499
Figure 33