Recommended Maintenance Schedule(S); Preparing For Maintenance; Checking The Engine Oil Level - Toro Power Max 926 OXE Operator's Manual

• If the engine slows down under a load or the wheels
slip, shift the machine into a lower gear.
• If the front of the machine rides up, shift the
machine into a lower gear. If the front continues to
ride up, lift up on the handles.
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 2 hours
After the first 5 hours
Before each use or daily
Every 50 hours
Every 100 hours
Yearly
Yearly or before storage
Important: You can find more information about maintaining and servicing your machine at
www.Toro.com.

Preparing for Maintenance

1. Move the machine to a level surface.
2. Stop the engine and wait for all moving parts to stop.
3. Disconnect the spark plug wire. Refer to Replacing
the Spark Plug.

Checking the Engine Oil Level

Service Interval: Before each use or daily—Check
the engine oil level and add oil if
necessary.
1. Remove the dipstick, wipe it clean, then fully install
the dipstick.
2. Remove the dipstick and check the oil level
(Figure 42). If the oil level is below the Add mark
Maintenance Procedure
• Inspect the traction cable and adjust it if necessary.
• Inspect the auger/impeller cable and adjust it if necessary.
• Change the engine oil.
• Check the engine oil level and add oil if necessary.
• Change the engine oil. Change the engine oil every 25 operating hours when
operating the engine under a heavy load.
• Replace the spark plug.
• Check the skids and adjust them if necessary.
• Inspect the traction cable and adjust or replace it if necessary.
• Inspect the auger/impeller cable and adjust or replace it if necessary.
• Check the auger gearbox oil and add oil if necessary.
• Lubricate the hex shaft.
• Check the air pressure in the tires and inflate them to 17–20 psi (116–137 kPa).
• Run the engine to dry out the fuel tank and the carburetor at the end of the season.
• Have an Authorized Service Dealer inspect and replace the traction drive belt and/or
the auger/impeller drive belt, if necessary.
on the dipstick, add oil. Refer to Filling the Engine
with Oil.
21