Connecting The Headlight And Handwarmer Wire To The Engine - Toro Power Max Heavy Duty 928 OHXE Operator's Manual

Figure 15
1. Short rod
4. Insert the front end of the rod into the opening in
the back of the chute-gear cover until it slides into the
chute gear (Figure 16).
Figure 16
5. Align the holes in the nested ends of the rods and
insert 2 carriage bolts (in the loose-parts bag) through
the short rod from the left side of the machine (from
the operating position).
6. Insert the cable clip that supports the deflector cable
onto the forward carriage bolt, and secure the carriage
bolts with locknuts from the loose-parts bag
17).
g018657
Figure 17
1. Cable clip
g018656
2. Long chute-control rod
(Figure
2. Deflector cable
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
5
Connecting the Headlight
and Handwarmer Wire to the
Engine
No Parts Required
Procedure
Plug a connector into the starter wire and another into the
ground (Figure 18).
Note: The pigtails are color-coded.
1. Starter-wire connector
9
Figure 18
2. Ground connector