Replacing The Drive Belts; Replacing The Headlight Bulb - Toro Power Max 926 OXE Operator's Manual

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have
an Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 899 37W halogen light bulb. Do not touch
the bulb with your hands or allow dirt or moisture to
come into contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 60).
Figure 60
2. Turn the base of the bulb counterclockwise until it
stops (Figure 61).
Figure 61
3. Remove the bulb straight out from the back of the
headlight (Figure 62).
Figure 62
4. Insert a new bulb into the back of the headlight
(Figure 63).
5. Turn the base of the bulb clockwise until it is snug
(Figure 64).
6. Insert the wire connector straight into the back of
the headlight until it is securely in place (Figure 65).
27
Figure 63
Figure 64
Figure 65