Filling The Engine With Oil; Checking The Tire Pressure - Toro Power Max 926 OXE Operator's Manual

Note: Ensure that the plastic clip on the wire
connector is on the bottom (Figure 18).
2. Secure a cable tie (from the loose parts bag) around
the wire and the handle about an inch (2.5 cm) below
the U-bolt (Figure 18).
6

Filling the Engine with Oil

No Parts Required
Procedure
Your machine comes with oil in the engine crankcase.
Note: Before starting the engine, check the oil level
and add oil if necessary.
Use automotive detergent oil with an API service
classification of SF, SG, SH, SJ, SL, or higher. Refer to
your engine owner's manual.
Use Figure 19 below to select the best oil viscosity for
the outdoor temperature range expected:
Engine Oil Capacities
Model
38661
38662
38663
1. Remove the dipstick by rotating the cap
counterclockwise and slowly pour oil into the oil
fill tube to raise the oil level to the Full mark on the
dipstick. Do not overfill. (Figure 20).
Figure 19
Engine Oil Capacity
30 to 32 oz. (0.89 to 0.95 l)
1. Full
2. Install the dipstick securely by pushing the cap down
flat and turning.
Note: Do not spill oil around the oil fill tube; oil
could leak onto traction parts and cause the traction
to slip.
7

Checking the Tire Pressure

No Parts Required
Procedure
The tires are overinflated at the factory for shipping.
Reduce the pressure equally in both tires to between 17
and 20 psi (116 and 137 kPa).
12
G016497
Figure 20
2. Add oil
1
2