Installing The Chute Control Rod - Toro Power Max 926 OXE Operator's Manual

1. Speed selector lever
2. Trunnion
Note: To make installation easier, leave the flat
washer on the trunnion (Figure 12).
4. Shift the speed selector lever into Position R2.
5. Rotate the lower link arm fully upward
(counterclockwise) (Figure 13).
6. Lift up on the speed control rod and insert the
trunnion into the hole in the speed selector lever
(Figure 12).
Note: If the trunnion does not fit into the hole
when you lift up on the speed control rod, rotate the
trunnion upward or downward on the speed control
rod until it fits.
7. Secure the trunnion and upper end of the speed
control rod with the outer washer and a hairpin
cotter you previously removed.
Figure 12
3. Inner washer
4. Outer washer
Figure 13
Note: For easier installation, look down through
the opening in the speed selector (Figure 14).
1. Speed selector
4
Installing the Chute Control
Rod
Parts needed for this procedure:
2 Carriage bolts
2 Locknuts
Procedure
1. Unwrap the Quick Stick and rotate it so that it is
upright and in the center.
2. Hold the blue trigger cap down and pull the lever
fully rearward.
Note: The discharge chute and deflector should
face forward. If they do not, hold the blue trigger
cap down (but do not move the Quick Stick) and
rotate the discharge chute until they do.
3. Align the flattened back end of the long chute
control rod with the flattened front end of the short
rod that extends from the control panel so that they
nest together (Figure 15).
10
Figure 14