Adjusting The Discharge Chute Latch - Toro Power Max 926 OXE Operator's Manual

2. Clean around the base of the spark plug.
3. Remove and discard the old spark plug.
Note: You will need a ratchet wrench extension to
remove the spark plug.
4. Set the gap between the electrodes on a new spark
plug at 0.030 inch (0.76 mm) (Figure 56).
1. 0.030 inch (0.76 mm)
5. Install the new spark plug, tighten it firmly, and
attach the ignition wire to the spark plug.
Note: Ensure the ignition wire snaps completely
into place on the spark plug.
Adjusting the Discharge Chute
Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge chute latch.
1. Remove the fastener on the gear cover (Figure 57),
lift the front of the cover up, and slide it back and
out of the way.
Figure 55
Figure 56
2. Loosen the bolt on the cable clamp (Figure 58).
G016646
1. Cable conduit
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (Figure 58 and Figure 59).
1. Discharge chute latch
Note: The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 59).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp, being careful
not to strip the plastic part.
6. Install and secure the gear cover.
26
Figure 57
Figure 58
2. Cable clamp
Figure 59
2. Gear teeth