Table of Contents
Advertisement
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
5
Connecting the Headlight
and Handwarmer Wire to the
Engine
No Parts Required
Procedure
Plug a connector into the starter wire and another into the
ground
(Figure
18).
Note: The pigtails are color-coded.
Figure 18
1. Starter-wire connector
6
Checking the Engine-Oil Level
No Parts Required
Procedure
Note: Your machine comes with oil in the engine
crankcase. Before starting the engine, check the oil level
and add oil if necessary.
Refer to
Checking the Engine-Oil Level (page
2. Ground connector
18).
7
Checking the Tire Pressure
No Parts Required
Procedure
The tires are overinflated at the factory for shipping. Reduce
the pressure equally in both tires to between 116 and 137
kPa (17 and 20 psi).
8
Checking the Skids and
Scraper
No Parts Required
Procedure
Refer to
Checking and Adjusting the Skids (page
9
Checking the Operation of the
Traction Drive
No Parts Required
Procedure
CAUTION
If the traction drive is not properly adjusted, the
machine may move in the direction opposite of
what you intended, causing injury and/or property
damage.
Carefully check the traction drive and adjust it
properly, if necessary.
1. Start the engine; refer to
2. Move the speed selector to Position R1; refer to
Operating the Speed Selector (page
9
19).
Starting the Engine (page
15).
12).
Advertisement
Table of Contents
