Connecting The Wire To The Headlight - Toro Power Max Heavy Duty 926 OXE Operator's Manual

Figure 15
1. Short rod
4. Insert the front end of the rod into the opening in
the back of the chute-gear cover until it slides into the
chute gear (Figure 16).
Figure 16
5. Align the holes in the nested ends of the rods and
insert 2 carriage bolts (in the loose-parts bag) through
the short rod from the left side of the machine (from
the operating position).
6. Insert the cable clip that supports the deflector cable
under the head of the forward carriage bolt, and secure
the carriage bolts with locknuts from the loose-parts
bag (Figure 17).
g018657
Figure 17
1. Cable clip
g018656
2. Long chute-control rod
2. Deflector cable
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
5
Connecting the Wire to the
Headlight
Parts needed for this procedure:
1 Cable tie
Procedure
1. Insert the wire connector on the loose end of the wire
straight into the back of the headlight until it is securely
in place (Figure
1
G016761
1. Plastic clip on wire
connector
2. U-bolt
Note: Ensure that the plastic clip on the wire
connector is on the bottom
2. Secure a cable tie (from the loose-parts bag) around the
wire and the handle about 2.5 cm (1 inch) below the
U-bolt (Figure 18).
9
18).
Figure 18
3. Cable tie
(Figure 18).
2
3