Table of Contents
Advertisement
Unsatisfactory cleaning result
Problem
The dishes are not clean.
Smearing appears on
glassware and cutlery.
There is a bluish sheen on
the surface of glassware;
film can be wiped off.
Crockery is not dry or
cutlery and glasses are
flecked.
Cause and remedy
The dishes were not loaded correctly.
Please observe the instructions in "Loading the
dishwasher".
The programme was not suitable for the load.
Select a more suitable programme (see "Programme
chart").
Not enough cleaning agent was dispensed.
Use more cleaning agent, or change the brand you are
using.
Items are blocking the path of the spray arms.
Rearrange the items so that the spray arms can rotate
freely.
The filter combination in the base of the wash cabinet is not
clean or is not correctly fitted.
This may cause the spray arm jets to get blocked.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets, if necessary (see "Cleaning and
care").
The non-return valve is open and blocked. Dirty water has
flowed back into the wash cabinet.
Clean the drain pump and the non-return valve (see
"Maintenance").
If necessary alter the temperature and / or the holding time
for the programme being used.
Change the relevant parameters for the programme. (see
"Further settings, Additional functions")
The rinsing agent dosage is set too high.
Reduce the dosage (see "Further settings, Additional
functions, Dispensing systems").
The rinsing agent dosage is set too low or the rinsing agent
reservoir or container is empty.
Replenish the rinsing agent, increase the dosage or
change the brand of rinsing agent used (see "Adding
rinsing agent").
Problem solving guide
105
Advertisement
Table of Contents
