Table of Contents
Advertisement
Operation
Setting the
dispensing
concentration
Refilling or
changing
containers
48
For adjusting dispensing concentration see "Further settings /
Additional functions / Dispensing systems".
The DOS module is equipped with a level indicator which gives a
message in the display when the level drops below the minimum.
DOS
Refill
Refill the appropriate chemical agent at the end of a programme as
soon as the message appears in the display.
Confirm the message shown with the OK button.
Refill the container in good time to prevent the dispensing system
being emptied completely.
An empty dispensing system must be vented before starting the
next programme.
Place the container on the open cabinet door or on a surface which
is easy to clean.
Unscrew and remove the siphon. Place the siphon on the open
cabinet door.
Refill the container or replace it with a full one.
Push the siphon into the opening of the container and screw it on
tightly. Observe the colour coding.
Wipe up any spilled chemical agent thoroughly.
Place the container on the floor beside the dishwasher or in an
adjacent cupboard.
Vent the dispensing system if necessary.
To vent the system and adjust the dosage amount, see
"Further settings, Additional functions".
K
OK
Advertisement
Table of Contents
