Table of Contents
Advertisement
General problems with the dishwasher
Problem
The dishwasher fails to
react when buttons are
pressed. The display and
indicator lights remain
dark.
The following fault
message appears in the
display:
Salt container lid not correctly
closed
The cleaning agent
dispenser lid cannot be
closed properly.
At the end of a programme
there is a film of moisture
on the inside of the door
and the interior cabinet
walls.
Water remains in the wash
cabinet at the end of the
programme.
(This does not apply to the
"Super short"
programme).
Cause and remedy
The dishwasher has switched itself off after the set "switch
off after" period to save energy.
Press the button to switch the dishwasher back on.
The salt reservoir lid has not been closed properly.
Close the salt reservoir lid.
Residual cleaning agent is blocking the catch.
Remove the cleaning agent.
This is not a fault.
It is caused by the drying system.
The moisture will dissipate after a short while.
Before rectifying the problem:
Switch the dishwasher off with the button.
The filter combination in the wash cabinet is clogged.
Clean the filter combination (see "Cleaning and care").
The drain pump or non-return valve may be blocked.
Clean the drain pump or the non-return valve (see
"Maintenance").
The drain hose is kinked.
Remove any kink from the drain hose.
The on-site drain siphon is blocked.
Check and clean the drain siphon.
Problem solving guide
103
Advertisement
Table of Contents
