EWM Taurus 351 Operating Instructions Manual page 41

Error Category
a)
Error 56 -
(no Pha)
Error 59
(Unit?)
Legend for categories (error reset)
a) The error message will disappear once the error has been rectified.
b) The error message can be reset by pressing a key button:
Welding machine control
RC1 / RC2
Expert
CarExpert / Progress (M3.11)
alpha Q / Concept / Basic / Basic S / Synergic /
Synergic S / Progress (M3.71) / Picomig 305
c) The error message can only be reset by switching the machine off and on again.
The shielding gas error (Err 6) can be reset by pressing the "Welding parameters" key button.
099-005341-EW501
27.01.2016
Possible cause
b) c)
- x Mains phase failure
Machine incompatible
Rectifying faults
Remedy
Check mains voltages
Check machine used
Key button
not possible
Error messages
41