Checking The Auger Gearbox Oil Level - Toro 38805 Operator's Manual

Figure 49
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable
7. Adjust the turnbuckle until you obtain the proper gap.
8. Tighten the jam nut.
9. Insert the 2 screws that you previously removed on
the belt cover.
10. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.
2. Turnbuckle
(Figure 49).
Checking the Auger Gearbox
Oil Level
Service Interval: Yearly—Check the auger gearbox oil and
add oil if necessary.
1. Move the machine to a level surface.
2. Clean the area around the pipe plug
1. Pipe plug
3. Remove the pipe plug from the gearbox.
4. Check the oil level in the gearbox. The oil should be at
the point of overflowing at the filler opening.
5. If the oil level is low, add GL-5 or GL-6, SAE 85-95
EP gear oil lubricant to the gearbox until the point of
overflow.
Note: Do not use synthetic oil.
6. Install the pipe plug in the gearbox.
23
(Figure 50).
1
G016782
Figure 50