Stopping The Engine; Operating The Traction Drive; Using The Wheel Clutch Levers - Toro 38805 Operator's Manual

Stopping the Engine

1. Move the throttle to the S
the S position
TOP
engine can also be stopped by pulling the ignition key
outward to the middle position.
2. Wait for all moving parts to stop before leaving the
operating position.
3. Remove the ignition key to prevent accidental starting.
4. Close the fuel shutoff valve by rotating it clockwise
(Figure 34).
5. Pull the recoil starter 3 or 4 times. This helps prevent
the recoil starter from freezing up.
position, and then to
LOW
(Figure 33) to kill the engine. The
G016505
Figure 33
G016499
Figure 34

Operating the Traction Drive

CAUTION
If the traction drive is not properly adjusted, the
machine may move in the direction opposite of
what you intended, causing injury and/or property
damage.
Carefully check the traction drive and adjust it
properly, if necessary; refer to
Traction Drive Operation (page 11)
information.
Important: If the machine moves when the traction
lever is in the released position, check the traction cable
(refer to Checking and Adjusting the Traction Cable
(page 22)) or take the machine to an Authorized Service
Dealer for service.
Important: To operate the traction drive, you must
operate the machine with the self-propel feature
engaged. Refer to Freewheeling or Using the Self-propel
Drive (page 13).
1. To engage the traction drive, squeeze the left (traction)
lever to the handgrip
2. To stop the traction drive, release the traction lever.

Using the Wheel Clutch Levers

The wheel clutch levers allow you to momentarily disengage
the drive to one or both wheels with the traction drive lever
still engaged. This enables you to turn and maneuver the
machine easily.
Note: Holding down the traction lever against the handle
engages the traction drive to both wheels.
To turn the machine to the right, lift up on the right wheel
clutch lever and squeeze it toward the handle
16
9 Checking the
for more
(Figure 35).
Figure 35
(Figure 36).