Replacing The Drive Belts; Replacing The Headlight Bulb - Toro 38805 Operator's Manual

Figure 60
1. Discharge chute latch
Note: The latch is spring loaded and will naturally
move into the teeth of the gear
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp, being careful not
to strip the plastic part.
6. Install and secure the gear cover.

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 899 37W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 61).
Figure 61
2. Turn the base of the bulb counterclockwise until it
stops (Figure 62).
2. Gear teeth
(Figure 60).
3. Remove the bulb straight out from the back of the
headlight (Figure
4. Insert a new bulb into the back of the headlight
64).
5. Turn the base of the bulb clockwise until it is snug
(Figure 65).
6. Insert the wire connector straight into the back of the
headlight until it is securely in place
26
Figure 62
63).
Figure 63
Figure 64
Figure 65
(Figure
(Figure
66).