Maintenance; Recommended Maintenance Schedule(S); Maintenance Safety; Preparing For Maintenance - Toro 38805 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 2 hours
After the first 5 hours
Before each use or daily
Every 25 hours
Every 100 hours
Yearly
Yearly or before storage
Important: You can find more information about maintaining and servicing your machine at www.Toro.com.

Maintenance Safety

Read the following safety precautions before performing any
maintenance on the machine:
•
Before performing any maintenance, service, or
adjustment, stop the engine and remove the key. If major
repairs are ever needed, contact an Authorized Service
Dealer.
•
Check all fasteners at frequent intervals for proper
tightness to be sure the machine is in safe working
condition.
•
Maintain or replace safety and instruction labels, as
necessary.
•
Do not change the governor settings on the engine.
•
Purchase only genuine Toro replacement parts and
accessories.

Preparing for Maintenance

1. Move the machine to a level surface.
2. Stop the engine and wait for all moving parts to stop.
3. Disconnect the spark plug wire. Refer to Replacing
the Spark Plug.
Maintenance Procedure
• Inspect the traction cable and adjust it if necessary.
• Inspect the auger/impeller cable and adjust it if necessary.
• Change the engine oil.
• Check the engine oil level and add oil if necessary.
• Change the engine oil.
• Replace the spark plug.
• Check the skids and adjust them if necessary.
• Inspect the traction cable and adjust or replace it if necessary.
• Inspect the auger/impeller cable and adjust or replace it if necessary.
• Check the auger gearbox oil and add oil if necessary.
• Lubricate the hex shaft.
• Check the air pressure in the tires and inflate them to 17–20 psi (116–137 kPa).
• Run the engine to dry out the fuel tank and the carburetor at the end of the season.
• Have an Authorized Service Dealer inspect and replace the traction drive belt and/or
the auger/impeller drive belt, if necessary.
20