Table of Contents
Advertisement
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable
7. Adjust the turnbuckle until you obtain the proper gap.
8. Tighten the jam nut.
9. Insert the 2 screws that you previously removed on
the belt cover.
10. If the auger/impeller cable is properly adjusted but
a problem remains, contact an Authorized Service
Dealer.
Checking the
Auger-Gearbox-Oil Level
Service Interval: Yearly—Check the auger-gearbox oil and
add oil if necessary.
1. Move the machine to a level surface.
2. Clean the area around the pipe plug
Figure 48
1. Pipe plug
3. Remove the pipe plug from the gearbox.
4. Check the oil level in the gearbox. The oil should be at
the point of overflowing at the filler opening.
5. If the oil level is low, add GL-5 or GL-6, SAE 85-95
EP gear oil lubricant to the gearbox until the point of
overflow.
Note: Do not use synthetic oil.
6. Install the pipe plug in the gearbox.
Changing the Engine Oil
Service Interval: After the first 5 hours—Change the engine
oil.
Every 50 hours—Change the engine oil. Change the
engine oil every 25 operating hours when operating
the engine under a heavy load.
If possible, run the engine just before changing the oil because
warm oil flows better and carries more contaminants.
Use automotive detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.
(Figure
47).
(Figure
48).
1
G016782
Use
Figure 49
below to select the best oil viscosity for the
outdoor temperature range expected:
Engine Oil Capacities
Model
38801
38802
1. Clean the area around the oil-drain cap
G016496
1. Oil-drain plug
2. Slide an oil-drain pan under the drain extension and
remove the oil-drain plug.
Note: When removing the plug, ensure that the tube
does not loosen.
3. Drain the oil.
Note: Dispose of the used oil properly at a local
recycling center.
4. Install the oil-drain plug.
5. Fill the crankcase with oil.
A. Remove the dipstick and slowly pour oil into the
oil-fill tube to raise the oil level to the Full mark
on the dipstick
23
Figure 49
Engine Oil Capacity
0.89 to 0.95 L (30 to 32 oz)
(Figure
Figure 50
(Figure
52). Do not overfill.
50).
1
Advertisement
Table of Contents
