Checking The Engine Oil Level; Checking And Adjusting The Skids - Toro 38805 Operator's Manual

Checking the Engine Oil Level

Service Interval: Before each use or daily—Check the engine
oil level and add oil if necessary.
1. Remove the dipstick, wipe it clean, then fully install
the dipstick.
2. Remove the dipstick and check the oil level
If the oil level is below the Add mark on the dipstick,
add oil. Refer to 6 Filling the Engine with Oil (page
(Figure
Figure 43
Checking and Adjusting the
Skids
Service Interval: Yearly—Check the skids and adjust them
Check the skids to ensure that the auger does not contact
43).
the paved or gravel surface. Adjust the skids as needed to
compensate for wear.
9).
1. Check the tire pressure. Refer to
Pressure (page
2. Loosen the nuts that secure both skids to the auger
sides until the skids slide up and down easily
44).
1. 1.3 cm (1/2 inch)
3. Support the side plates so that they are at least 1.3 cm
(1/2 inch) above a level surface.
Important: The auger blades must be supported
above the ground by the skids.
4. Ensure that the scraper is 3 mm (1/8 inch) above and
parallel to a level surface.
Note: If the pavement is cracked, rough, or uneven,
adjust the skids to raise the scraper. For gravel surfaces,
adjust the skids further down to prevent the machine
from picking up rocks.
5. Move the skids down until they are even with the
ground.
6. Firmly tighten the nuts that secure both skids to the
auger sides.
Note: To quickly adjust the skids if they loosen,
support the scraper 3 mm (1/8 inch) off the pavement,
then adjust the skids down to the pavement.
Note: If the skids become excessively worn, you can
turn them over and set the unused side toward the
pavement.
21
if necessary.
7 Checking the Tire
10).
Figure 44
(Figure