Checking And Adjusting The Traction Cable; Checking And Adjusting The Auger/Impeller Cable - Toro 38805 Operator's Manual

Checking and Adjusting the
Traction Cable
Service Interval: After the first 2 hours—Inspect the
traction cable and adjust it if necessary.
Yearly—Inspect the traction cable and adjust or
replace it if necessary.
If the machine does not drive in the forward or reverse speeds
or it drives when you release the traction lever, adjust the
traction cable.
With the traction lever disengaged, check the pin in the
elongated slot in the left side of the machine above the tire.
There should be a gap of 1 to 1.5 mm (1/32 to 1/16 inch)
from the front of the slot to the front edge of the pin
45).
1. Pin
2. 1 to 1.5 mm (1/32 to 1/16 inch)
If the left hand (traction) cable is not properly adjusted, do
the following steps:
1. Loosen the jam nut.
2. Loosen or tighten the turnbuckle to adjust the pin until
it is the proper gap from the front edge of the slot.
3. Tighten the jam nut
1. Jam nut
Figure 45
(Figure 46).
Figure 46
2. Turnbuckle
Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
Yearly—Inspect the auger/impeller cable and adjust
or replace it if necessary.
1. Remove the 2 screws from the right side of the belt
cover as shown.
2. Lift up the right side of the belt cover
(Figure
3. With the auger/impeller lever disengaged, ensure that
the gap between the auger clutch assembly and the tab
is 1.5 mm (1/16 inch) as shown in
1. Tab
2. 1.5 mm (1/16 inch)
4. If the auger/impeller cable is not properly adjusted, do
the following steps:
5. Loosen the jam nut
22
auger/impeller cable and adjust it if
necessary.
(Figure
Figure 47
Figure
Figure 48
(Figure 49).
47).
48).