Connecting The Electricity - Baumatic BSIH32-ANZ Instruction Manual

kets should be fastened to the existing holes
on the bottom part of the casing (two in the
front and two in the back). There are two
possibilities of where the brackets may be
placed, just as is shown in figure 3.
fig. 3
Depending on the thickness of the cabinet, it
may be necessary to use the self tapping
screws that are provided as compliments for
securing; insert them in the circular holes of
the bracket. The thread of this hole will be
made when the screw is inserted inside of it.
The thread should be made before faste-
ning the bracket to the hob.

Connecting the electricity

The electric connection is made via an
omnipolar switch or plug where accessible,
which is suitable for the intensity to be tole-
rated and which has a minimum gap of 3
mm between its contacts, which will ensure
disconnection in case of emergency or
when cleaning the hob.
If the flexible supply cable fitted to these
appliances ever needs to be changed, it
should be replaced by the manufacturer's
official service.
The input cable should not be in contact
either with the body of the hob or with the
body of the oven, if the oven is installed in
the same unit.
10
Sealing washer
Sealing washer
When using the hob for the first
time, please take care not to have
powerful halogen lights, like those of a
hood, shining over the sensor button
area of the hob. These lights may inter-
fere with the starting of the system.
The electrical connection must be
properly grounded, following current
regulations, otherwise the stovetop
may malfunction.
Unusually high power surges can
damage the control system (like with
any electrical appliance).