Set Mode - Icom IC-M200 Instruction Manual

■ Set mode

In the Set mode, you can change the settings of the
transceiver's functions.
NOTE: Available functions may differ depending on
the dealer setting. Ask your dealer for details.
D Set mode operation
1. Turn OFF the transceiver.
2. While holding down [16/C], turn ON the
transceiver.
• Enters the Set mode.
• "SCAN" is displayed.
3. Push [16/C] several times until your desired item is
selected.
4. Push [▲] or [▼] to change the setting.
5. Turn OFF the transceiver, then ON again to exit
the Set mode.
SET MODE
D Set mode sequence
• Scan type
Starts with this item
Push
• FAV on MIC
Scrolls
6
• Scan resume timer
• Dual/Tri-watch
• Key Beep
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
12