Troubleshooting - Icom IC-M200 Instruction Manual

8

TROUBLESHOOTING

PROBLEM
Power does not come
on when turning ON the
transceiver.
No sound is heard from the
speaker.
Cannot transmit or output
power is low.
Scan does not start.
No beeps.
17
POSSIBLE CAUSE
Power cable is improperly
connected.
Volume level is too low.
Speaker has been exposed to
water.
Squelch level is too high.
Channels that are only for receive
or low power are selected.
Low power is selected.
"TAG" channels are not set.
Key beeps are OFF.
SOLUTION
Reconnect the DC power cable
correctly.
Rotate [VOL] to a suitable listening
level.
Drain water from the speaker.
Set squelch to the threshold point.
Select other channels.
Push [HI/LO] on the microphone to
select high power.
Set the channels you want to scan
as "TAG" channels.
Turn ON the key beep in the Set
mode.
REF.
p. 14
p. 6
p. 8
p. 6
p. 18
p. 6
p. 10
p. 13