Emergency Transmission - Icom IC-F9011B Operating Manual

2
ANALOG MODE OPERATION
n Emergency transmission
When [Emergency] is held down for the preset time period,
the DTMF emergency signal is transmitted once, or repeat-
edly , on the specified emergency channel.
* 1
A repeat emergency signal is automatically transmitted until
turning the transceiver OFF, or pushing [Home]
When no emergency channel is specified, the signal is trans-
mitted on the previously selected channel.
If you want to cancel the emergency call, hold down [Emer-
gency] again before transmitting the call.
If your transceiver is programmed for Silent operation, you
can transmit Emergency calls without the beep sounding or
the LCD display lighting.
IMPORTANT: It is recommended to set an emergency
channel individually to provide the certain emergency call
operation.
* 1 Depending on the presetting.
* 2 For only transceivers whose revision number is 1.7 or later.
13 13
D NOTES
Depending on the presetting, the following functions are au-
tomatically activated.
• Auto TX function
.
* 2 The transceiver automatically transmits the microphone audio
for the preset time period after the emergency call transmis-
sion.
- The HM-148G or HM-152
transceivers.
• Auto RX function
The transceiver stands by in the audible mode for the preset
time period, after the emergency call transmission.
is required for Mobile
hand microphone