Table of Contents
Advertisement
"On/off sensor" (1)
Please note: Any zones that are still hot to the touch will display an
" " provided the mains power supply is not interrupted.
Booster
•
The hob is equipped with a booster function on all zones, allowing
a higher power level than the maximum for approximately ten
minutes. To turn on the booster function, touch the booster sensor
(9) and then use the "+" sensor (2) for the desired zone. "P" will show
in the cooking zone indicator to show that the booster is on.
•
The booster function automatically deactivates after 10 minutes of
usage. The cooking zone will continue to operate at its nominal
power at this point. The booster can be reactivated after this time
provided the hob's internal components have not overheated.
•
To cancel the booster at any time, lower the heat setting using the
"-" sensor (3).
Please note: If no zone is selected within approximately four seconds
of touching the booster sensor (9) then the hob will beep and the
booster function setting will be cancelled.
The booster function cannot be used on two vertically arranged, or
bridged, cooking zones at the same time. This is to prevent damage
to the internal modules caused by overheating. In the case of
bridging, the booster function can still be used on one zone. The
power of the un-boosted zone may be reduced depending on the
size of the pans being used.
for approximately two seconds.
9
Advertisement
Table of Contents
