Table of Contents
Advertisement
•
Using the timer "+" sensor (5) or the timer "-" sensor (6), set the
desired cooking time (in minutes) to between 0 and 99. The
selection will confirm in approximately 10 seconds, the timer display
will show the time set and the countdown will start.
•
If no time is set within ten seconds, the timer display (7) will
become inactive and the zone will continue cooking.
At the end of the timer, the selected zone will switch off and the timer
display, and relevant timed zone LED, will flash. The hob will beep for
approximately two minutes. To switch off the beep and the flashing
display, touch either the timer "+" or "-" key. This beeping also occurs
after the minute minder time has elapsed and the same process to
switch off the beep applies.
Please note: The timer duration can be adjusted at any time during
the countdown. Simply follow the steps for setting the timer and
amend the minutes as necessary.
To cancel the timer
•
Touch the timer "+" and "-" sensors (5 and 6) simultaneously to
re-activate timer adjustment. Using the "-" sensor set the time to 0.
After approximately 10 seconds the timer on the relevant zone will
be cancelled.
•
Do this for each zone if necessary. Use the "+" and "-" sensors
to cycle through the timed zone LEDs until the desired timed zone
LED is flashing.
•
Cancelling the timer will not switch off a zone. You should switch
the zone off manually if required.
13
Advertisement
Table of Contents
