Miele PG 8061 Operating Instructions Manual page 47

Setting the dis-
pensing concen-
tration
Refilling or
changing contain-
ers
Unused connectors must be covered with safety caps to prevent
the leakage of wash water.
For information about setting the dispensing concentration, see "Ad-
ditional settings / Additional functions / Dispensing systems".
The DOS module is equipped with a level monitor which shows a
message in the display when the amount drops below the minimum
level.
Refill DOS
Refill the appropriate process chemical at the end of a program

whenever the message appears in the display.
Acknowledge the message with the OK button.

Refill the container ahead of time to prevent the dispensing system
from being fully emptied.
An empty dispensing system must be vented before the next pro-
gram is started.
Place the container on the open cabinet door or on a surface which

is easy to clean.
Unscrew and remove the siphon. Place the siphon on the open

cabinet door.
Refill the container or replace it with a full one.

Push the siphon into the opening of the container and screw it on

tightly. Be sure to observe the color coding.
Wipe up any spilled process chemicals thoroughly.

Place the container on the floor beside the dishwasher or in an ad-

jacent cabinet.
Vent the dispensing system if necessary.

K
OK
Operation
47