Electrical Connection - Miele PG 8527 Operating Instructions Manual

Electrical connection

All electrical work must be carried
out by a qualified electrician in
accordance with local and national
safety regulations.
– Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer can
not be held responsible for
unauthorized work.
– For hard-wired machines connection
should be made via a suitable
isolator, with an on-off switch which
is easily accessible for servicing and
maintenance work after the machine
has been installed. An electrical
safety test must be carried out after
installation and after any servicing
work. When switched off there must
be an all-pole contact gap of at least
3 mm in the mains connection
switch.
– For extra safety it is advisable to
protect the machine with a 30 mA
residual current device (RCD).
– Check that the phase rotation is
correct when connecting the
machine.
^ For technical data see the data plate
or wiring diagram supplied.
The washer-disinfector must only be
operated with the voltage, frequency
and fusing shown on the data plate.
The data plate is on the cover plate
behind the service panel of the unclean
side.
The wiring diagram is secured to the
inner side of the service panel.
70
This machine can be converted in
accordance with the conversion
diagram and wiring diagram supplied.
Further notes on electrical
connection are given on the
installation diagram supplied with
the machine.
WARNING:
THIS APPLIANCE MUST BE
GROUNDED