b.Disassemble 4 bolts showing in the photo, remove the wire heater and take out the insulating strip.
Frame-R
Frame-L
insulating strip
Screw
Wire-Heater
Wire-Heater
c.Remove the heater and replace it with a new one.
d.Follow the reverse order to reassmble insulating strip and wire-heater.
3.4 Replacing the Sub-PCB
a. Remove the Right cover .(Refer to "3.1 Replacing the right cover")
b. Disconnect the Motor-controller, unfasten screws marked with red circle .
Screw
connector
c.Change the Sub PCB
14
d. Reassmble the Sub PCB following the reverse order showing above.