Table of Contents
Advertisement
WAN 1/2 Interface
Using the WAN 1/2 Interface, the Administrator sets up the WAN 1/2 network. These IP
Addresses are real public IP Addresses, and are routable on the Internet.
For PPPoE (ADSL User): This option is for PPPoE users who are required to enter a
username and password in order to connect, such as ADSL users.
Current Status: Displays the current line status of the PPPoE connection.
IP Address: Displays the IP Address of the PPPoE connection
Username: Enter the PPPoE username provided by the ISP.
Password: Enter the PPPoE password provided by the ISP.
IP Address provided by ISP:
Dynamic: Select this if the IP address is automatically assigned by the ISP.
Fixed: Select this if you were given a static IP address. Enter the IP address that is
given to you by your ISP.
Max. Upstream/Downstream Bandwidth: The bandwidth provided by ISP.
Service-On-Demand:
Auto Disconnect: The PPPoE connection will automatically disconnect after a length
of idle time (no activities). Enter in the amount of idle minutes before disconnection.
Enter „0‟ if you do not want the PPPoE connection to disconnect at all.
Ping: Select this to allow the WAN 1 network to ping the IP Address of the
Multi-Homing Gateway. This will allow people from the Internet to be able to ping the
Multi-Homing Gateway. If set to enable, the device will respond to echo request
packets from the WAN 1/2 network.
Http: Select this to allow the device WEBUI to be accessed from the WAN 1 network.
This will allow the WEBUI to be configured from a user on the Internet. Keep in mind
that the device always requires a username and password to enter the WEBUI.
- 60 -
Advertisement
Table of Contents
