Certification - Siemens CP 243-1 Operating Instructions Manual

Certification

Approvals issued
NOTICE
Issued approvals on the type plate of the device
The specified approvals - with the exception of the certificates for shipbuilding - have only
been obtained when there is a corresponding mark on the product. You can check which of
the following approvals have been granted for your product by the markings on the type
plate. The approvals for shipbuilding are an exception to this.
Certificates for shipbuilding and national approvals
The device certificates for shipbuilding and special national approvals can be found on the
Internet pages of Siemens Automation Customer Support under the following entry ID:
10805878 (http://support.automation.siemens.com/WW/view/en/10805878)
Under this entry, go to the required product and select the following settings: "Entry list" tab >
entry type "Certificates".
Standards and test specifications
The device meets the following standards and test specifications. The test criteria for the
module are based on these standards and test specifications.
CE declaration of conformity
The CP meets the requirements and safety-related aims of the following EC directives:
● EC Directive 2004/108/EEC "Electromagnetic Compatibility" (EMC Directive)
● EC directive 94/9/EC "Equipment and protective systems intended for use in potentially
The EC Declaration of Conformity is available for all responsible authorities at:
CP 243-1
Operating Instructions, 03/2012, C79000-G8976-C244-02
– Immunity
EN 61000-6-2:2005: Industrial area
explosive atmospheres" (ATEX Explosion Protection Directive)
– EN 60079-15:2005: Type of protection 'n':
7
121