Using Your Ceramic Cooktop - Westinghouse WFE914SB User Manual

USING YOUR CERAMIC COOKTOP

Switching the ceramic cooktop on and off
CONTROL PANEL
Switch on
Touch for 2 seconds
Switch off Touch
for 2 seconds
TIPS & INFORMATION
TIPS AND INFORMATION
After switching on, within approx. 10 seconds a heat setting
or a function must be set, otherwise the appliance
automatically switches itself off.
Setting the heat setting
CONTROL PANEL
To increase
Touch
To decrease Touch
To switch off
Touch until
TIPS & INFORMATION
TIPS AND INFORMATION
The keep warm setting lies between
to keep food warm.
Switching the outside ring on and off
By switching the outside rings on or off, the effective
heating surface can be matched to the size of the
cookware.
TIPS & INFORMATION
TIPS AND INFORMATION
Before an outside ring can be switched on, the inside ring
must be switched on.
TRIPLE CONTROL
COOKING ZONE PANEL
To switch on the
Touch
middle ring
1-2 seconds
To switch on the
Touch
outside ring
1-2 seconds
To switch off the
Touch
outside ring
1-2 seconds
To switch off the
Touch
middle ring
1-2 seconds
MULTI-PURPOSE SENSOR
ZONE FIELD
To switch on the
Touch
outside ring
1-2 seconds
To switch off the
Touch
outside ring
1-2 seconds
DISPLAY
/
/ none
DISPLAY
to
to
and . It is used
INDICATOR LIGHT
Two indicator lights
for
are lit
Three indicator
for
lights are lit
The third indicator
for
light goes out
The second indicator
for
light goes out
INDICATOR
LIGHT
for
is lit
for
goes out
Locking/unlocking the control panel
The control panel, with the exception of the 'On/Off'
sensor field, can be locked at any time in order to prevent
the settings being changed eg. By wiping over the panel
with a cloth.
CONTROL
PANEL
Switch on
Touch
Switch off
Touch
TIPS & INFORMATION
TIPS AND INFORMATION
When you switch the appliance off, the locking function is
automatically switched off.
Using the automatic warm-up function
All cooking zones are equipped with an automatic warm
up function. When setting a heat setting using
starting from , the cooking zone switches to full power
for a certain amount of time and then automatically
switches back to the heat setting set.
CONTROL
PANEL
Switch on
(only when
Touch
starting at )
Switch off Touch
Not used Touch
TIPS & INFORMATION
TIPS AND INFORMATION
If during the automatic warm up
is selected, e.g. from to
adjusted.
If there is still residual heat on the cooking zone
(display ), the automatic warm up is not performed.
USING YOUR CERAMIC COOKTOP
DISPLAY
(for 5 seconds)
the previously set
heat settings
, when
POSSIBLE
HEAT DISPLAY
SETTINGS
(after
to
5
seconds)
to / to
to to
a higher heat setting
, the automatic warm up is
15