Westinghouse WFE914SB User Manual page 11

INSTALLING YOUR COOKTOP
ACCESSORIES
Installing trivets
• The rubber feet on the trivets locate into the
contours
of the hob
• Take care when placing the trivets as dropping them
may damage the hob or trivet
• The wok trivet sits on top of the trivet above the wok
burner
Wok trivet
Wok burner
Using your gas hotplates
NOTE: Gas controls turn anticlockwise from 'Off' and
have limited movement.
INSTALLING BURNERS
AND TRIVETS
Lighting the burners
Electronic ignition
These hobs are fitted with mains powered electronic
ignition. When the appliance has been connected and the
power is on, depressing any knob will release sparks to all
burners. To light a burner, depress the corresponding knob
and while continuing to depress knob turn anticlockwise
to 'HI' position. The knob may be released once the flame
is established, and turned further anticlockwise to reduce
the flame height as desired.
Flame safeguard models WFE914SB & WFEP915SB
Trivets
Models with flame safeguard have the same ignition
procedure as electronic ignition, but require the knob to
continue to be depressed after flame is established for
approximately 5 seconds. If the flame goes out when the
knob is released, simply depress the knob again, this time
holding it down with slightly more force for the same
length of time.
WARNING
WARNING
Burner cap
• Keep hands clear of burners when lighting.
• If burner does not light within 5 seconds, turn knob to
'Off' position, allow gas to disperse, then try lighting
again.
• Burners MUST be operated between 'HIGH' and 'LOW'
settings only.
Burner crown
ENVIRONMENTAL TIPS ENVIRONMENT
To conserve gas, place the pan centrally over the burner
and adjust the flame so that it does not go past the edge
of the cookware.
NOTE: In the absence of electrical power, carry out the
ignition directly to the burner with a hand held ignition
source.
INSTALLING YOUR COOKTOP ACCESSORIES
11