Setting The Module Power (Module/Module Power) - Sony UPX-C200 Operating Instructions Manual

A new passkey has been set, and the display returns
to Bluetooth Menu.
To cancel changing the passkey setting
In Step 8 above, select CANCEL instead of OK, then
press ENTER of the control button.
Changing the passkey of the printer
1
Turn on the printer.
"Ready BT RSSI [----]"appears on the operation
display.
2
Press the MENU button.
3
Press V of the control button to display "Bluetooth
SETTING [>>]."
4
Press B of the control button.
"Bluetooth ADDR" appears.
5
Press V of the control button to display "PASSKEY
INPUT [>>]."
6
Press B of the control button.
"PASSKEY INPUT <1> [X:X:X:X]" appears.
Current digit to be set
7
Press b or B of the control button to select a digit
of the passkey to be changed.
This <1> shows the leftmost digit, and <4> shows
the rightmost digit.
8
Press v or V of the control button to set the value
of the passkey.
A value from 0 to 9 can be used.
Repeat Steps 7 and 8 until the four-digit passkey is
set.
9
Press the EXEC button.
"PASSKEY INPUT Saving..." appears, and your
passkey setting is stored.
10
When the setting is completed, press the MENU
button.
| |
Passkey
Setting the Module Power
(MODULE/MODULE POWER)
The Bluetooth Module Power must be set to ON to
connect the camera and the printer using the Bluetooth
function. If it is set to OFF, the Bluetooth lamp does not
light, and Bluetooth connection between devices is not
possible.
Changing the setting for Module Power
of the camera
1
Display the Setup display.
For details, see "Displaying the Setup Display" on
page 14.
2
Press v or V of the control button to select
Bluetooth.
3
Press ENTER of the control button.
The Bluetooth Menu display appears.
4
Press v or V of the control button to select
MODULE.
5
Press ENTER of the control button.
The BT MODULE POWER display appears.
6
Confirm that either ON or OFF is selected, then
press ENTER of the control button.
The display returns to Bluetooth Menu.
To cancel changing the setting
In Step 6, press b of the control button. The display
returns to Bluetooth Menu.
Changing the setting for Module Power
of the printer
1
Turn on the printer.
2
Press the MENU button.
3
Press V of the control button to display "Bluetooth
SETTING[>>]."
4
Press B of the control button.
"Bluetooth ADDR" appears.
5
Press V of the control button to display "MODULE
POWER [>>]."
Setting the Bluetooth Functions
25