HP StorageWorks XP24000 User Manual page 123

Table 32 Mapping Path Statuses and Required Actions (continued)
Status
LDEV size reduced
Not ready
Illegal request
Command aborted
Busy
LDEV reserved
Response error
Initiator port
Unknown port
HP Confidential
Description
example, the path definition was
deleted, or the external storage system
itself was replaced by another device. information about the mapped device
The setting of the volume capacity of
the external storage system has been
changed (the volume capacity was
reduced).
The reply of the external storage
system was NOTREADY. The drive of
the external storage system is spinning
up, or the device of the external
storage system is being formatted.
The reply of the external storage
system was ILLEGALREQUEST. The
command cannot be executed to the
device of the external storage system.
The data protection may be set on the
device of the external storage system.
The reply of the external storage
system was ABORTEDCOMMAND.
An error may have occurred on the
external storage system side.
The external storage system is in the
BUSY status.
The external storage system is in the
Reserve status. You are not allowed to
access the device of the external
storage system from the local storage
system.
The external storage system is in the
blocked status caused by the abnormal
reply (Response). You may not be able
to access the device of the external
storage system. Or data protection
may be set on the device of the
external storage system.
The port attribute of the external
storage system has been changed to
the initiator port.
The port attribute of the external
storage system is unknown.
Action
your external storage system, and check
if the operation that changes the setting
has not been performed.
Check the volume capacity of the
volume of the external storage system.
Execute the Delete Volume operation,
and then retry the Add Volume
operation.
The path cannot be used to access the
external storage system. Check the
status of the external storage system. If
you cannot restore the path, call HP
technical support.
The port of the external storage system
is recognized. Check the setting of the
external storage system. If you cannot
restore the path, call HP technical
support.
The port of the external storage system
is recognized. Check the setting of the
external storage system and the
condition of the connection (for
example, cables, switches) to the
external storage system. If you cannot
restore the path, call HP technical
support.
The port of the external storage system
is recognized. Check the setting of the
external storage system and the load
on the external storage system (for
example, check if the configuration
gives too much load on the external
storage system or not). If you cannot
restore the path, call HP technical
support.
Remove the Reserve status on the device
of the external storage system.
The port of the external storage system
is recognized. Check the setting and
status of the external storage system. If
you cannot restore the path, call HP
technical support.
Set the port attribute of the external
storage system to the target port. If you
cannot restore the path, call HP
technical support.
The port of the external storage system
is recognized. Check the condition of
the connection (for example, cables,
switches) to the external storage system.
Troubleshooting for XP External Storage 123