Table 28 UnitePathGroup Tag Parameters (continued)
Layer
Column in
Spreadsheet
The second layer
A
B
Example of a Spreadsheet
This section shows an example of a spreadsheet that can be used for mapping an external volume
in the following configuration:
An external volume is configured as follows:
◦
Map the volume to which 0001 is configured as a LUN that can be discovered through
the primary path.
◦
Use 1 for a path group number.
◦
Configure E16384-4095 for an external volume group (ExG).
Two cross-subsystem paths are configured as follows:
◦
The primary path
Port number on the local storage system: 1A
WWN on the external storage system: 60060E8004F81370
◦
The alternate path
Port number on the local storage system: 1B
WWN on the external storage system: 60060E8004F81371
Attributes of an external volume are configured as follows:
◦
Emulation type: OPEN-V
◦
Cache mode: Enable
◦
Inflow control: Disable
◦
CLPR: 00
LDEVs are configured as follows:
◦
Number of LDEVs: 3
◦
LDEV number: 00:00:00, 00:01:00, 00:02:00
◦
LDEV capacity: 96,000 blocks
Example:
#!Version 50_02_01, CLI_ExternalStorage, VolumeOperationFibre,;
[SerialNumber]
65536,;
[AddVolumeSetting]
1,1A,60060E8004F81370,0001,E16384-4095,Normal,00,OPEN-V,Enable,Disable,;
1 12
Using Spreadsheets for XP External Storage Operations
Parameter
Setting
Information about the path group that you want to change.
+
Identifier.
TargetPathGroup
Path group
number.
Range of Values
Number of
Characters
N/A
N/A
0 to 63231
5 decimal digits or
less
HP Confidential