Table of Contents
Advertisement
Do not attempt to service the EPSON Stylus Scan yourself.
Unplug the Stylus Scan and refer servicing to qualified service
personnel under the following conditions:
The power cord or plug is damaged; liquid has entered the
Stylus Scan; the Stylus Scan has been dropped or the cabinet
damaged; the Stylus Scan does not operate normally or
exhibits a distinct change in performance.
If you are using the Stylus Scan in Germany, observe the
following:
To provide adequate short-circuit protection and over-
current protection for this Stylus Scan, the building
installation must be protected by a 16 Amp circuit breaker.
Bei Anschluß des Druckers an die Stromversorgung muß
sichergestellt werden, daß die Gebäudeinstallation mit einem
16 A- Überstromschalter abgesichert ist.
A Few Precautions
When using the Stylus Scan
Do not put your hand inside the Stylus Scan or touch the print
head during operation.
Do not move the print head by hand. Doing so may damage
the EPSON Stylus Scan.
Always turn of the Stylus Scan using the P power button.
When this button is pressed, the P power light flashes briefly
and then goes off. Do not unplug the Stylus Scan or turn off
the power to the outlet until the P power light stops flashing.
2-4
Safety Instructions
Advertisement
Table of Contents
