Viewing Names Of Bypassed Points; Passcodes Option - Honeywell LYNX Touch 7000 Owner's Manual

Use the UP arrow key to scroll through a list of all the bypassed points.
You can use up to ten passcodes in your system. Three levels of passcode security
are available: Master, Family, and Guest. Each passcode can be programmed as
temporary (one-time only) or for an unlimited number of uses. All passcodes have the
same length. At the time your system is installed, you can choose to have your
passcode be 4, 5, or 6 digits in length. Once created, they can be enabled, disabled,
or changed at your discretion, but only when using a Master passcode.
A Master passcode allows access to every function of your system. Family passcodes
do not allow a user to change or disable other passcodes. Depending on how they are
programmed, Family passcodes optionally can operate Special Protection and Force
Arm the system, but they cannot individually bypass a point. Guest passcodes can
only Arm and Disarm the system when all points are normal.
Family passcodes numbered 6 through 10 will cause a pager call when disarming the
system. These pager numbers must be configured during installation.
For your protection, the actual passcode is not displayed on the keypad when you
enter it.
IMPORTANT
The system will not allow you to create a passcode that begins with the
same number as your Duress Digit.

Viewing Names of Bypassed Points

41

Passcodes Option

74-2760—1