Setup; Loose Parts; Installing Frame Mount To Traction Unit - Toro 30823 Operator's Manual

Setup

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use this chart as a checklist to ensure that all parts necessary for assembly have been received. Without these parts,
total setup cannot be completed. Some parts may have already been assembled at the factory.
Description
Frame Mount
Pivot Pin
Cotter Pin–5/32 x 1–3/4
Capscrew
Flatwasher
Nut
Drive Shaft
Capscrew
Nut
Roll Pin
Decal
Operator's Manual
Part Catalog
Danger
Do not start the engine and engage the PTO lever
when PTO shaft is not connected to blower gear
box because the PTO shaft will rotate with enough
force to cause serious injury.
Installing Frame Mount to
Traction Unit
Note: Traction unit must be equipped with larger carrier
bracket pin, part no. 98–2328. If the traction unit serial
number is 70001 or prior and is equipped with old style
bracket, part no. 92–9786, a new bracket must be obtained
from your Toro Distributor.
1. Park the machine on a level surface, lower the cutting
unit to the floor, engage the parking brake, be sure the
traction pedal is in the neutral position, the PTO lever is
in the OFF position, shut the engine OFF and remove
the key from the switch. Move lift lever to FLOAT
position.
2. Remove the cutting unit or other attachment from the
traction unit. Refer to cutting unit or attachment
operator's manual.
3. On right side of the traction unit, loosen (do not
remove) the wheel nuts securing wheel and tire
assembly to front wheel studs.
Qty. Use
1
2
2
Install frame mount to blower & traction unit
6
12
6
1
4
Mount drive shaft to blower & traction unit
4
2
1 Apply over decal part number 105–0707 for CE
1 Read Before Operating Machine
1
4. Jack up machine until the front wheel is off the floor.
Use jack stands or block the machine to prevent it from
falling accidentally.
5. Remove wheel nuts and slide wheel and tire assembly
off studs.
6. Mount frame mount to pivot bracket with a large pivot
pin and cotter pin (Fig. 1). Grease fitting to be
positioned downward.
1
Right Side Shown
1. Pivot pin
2. Frame mount
7. Mount rear of frame mount to lift cylinder with pivot
pin and (2) cotter pins (supplied with traction unit).
8. Hook brake return spring to hole in frame mount.
7
4
3
Figure 1
3. Lift arm pivot bracket
4. Brake return spring
2