Table of Contents
Advertisement
Figure 10
1. N
button
OZZLE DIRECTION
2. Throttle/Engine speed
4.
After the engine starts, move the choke control
to the O
position. If the engine stalls or
FF
hesitates, move the choke back to the R
position for a few seconds, then set the engine
speed to the desired setting. Repeat this as
required.
Shutting Off the Engine
1.
Decrease the engine speed to 3/4 throttle.
2.
Rotate the remote ignition key to the O
position.
3.
If leaving the machine, rotate the engine key to
the O
position and remove it from the switch
FF
(Figure
10).
g018877
3. Ignition switch
UN
FF
Adjusting the Nozzle
Direction
Press the nozzle direction button to rotate the nozzle
to the desired direction
1. Nozzle direction button
2. Throttle/Engine speed
Moving the Machine from
the Job Site
Important:
Raise the blower nozzle before
moving the machine from the job site. If you leave
the blower nozzle in the down position during
transport, the nozzle may contact the ground, and
become damaged.
16
(Figure
11).
Figure 11
3. Ignition switch
g018877
Advertisement
Table of Contents
