Toro TX525 Service Manual page 379

DRIVE SYSTEM
6. Start the machine and raise the loader arm enough
to clear the hydraulic floor jack. Place the floor jack
directly below the mount plate and lower the loader
arm onto the hydraulic floor jack. Continue lowering
the loader arm to raise the tracks off the ground (Fig.
1265).
7. Place two jack stands under the front frame (Fig.
1266).
7-2
Fig 1265 PICT-4250
Fig 1266 PICT-4251
8. Lower the hydraulic floor jack so the machine rests
on the jack stands. Lower the loader arms to the
resting position (Fig. 1267).
9. Make sure the machine is securely supported by the
jack stands.
Rev. 000
Fig 1267 PICT-4253
TX525 Service Manual