Toro TX 1000 Operator's Manual
High volume bucket compact tool carriers
Hide thumbs
Also See for TX 1000:
- Operator's manual (60 pages) ,
- Installation instructions manual (8 pages) ,
- Installation instructions (4 pages)
Related Manuals for Toro TX 1000
Summary of Contents for Toro TX 1000
- Page 1 Form No. 3430-859 Rev A High Volume Bucket TX 1000 Compact Tool Carriers Model No. 22342—Serial No. 404700000 and Up *3430-859* A Register at www.Toro.com. Original Instructions (EN)
- Page 2 Introduction 1. Model and serial number location The bucket is a load-bearing attachment intended to be used on a Toro tool carrier. It is designed primarily Model No. for moving rock, dirt, sand, or other materials. Using this product for purposes other than its intended use could prove dangerous to you and bystanders.
-
Page 3: Table Of Contents
Contents Safety Safety ............... 3 DANGER General Safety ........... 3 Slope Safety ............3 There may be buried utility lines in the work Bucket Safety ............. 4 area. Digging into them may cause a shock Maintenance and Storage Safety......4 or an explosion. -
Page 4: Bucket Safety
Bucket Safety load-bearing attachment makes the rear of the machine the heavy end, and a full load-bearing • Wear gloves, eye protection, long pants, attachment makes the front of the machine the substantial slip-resistant footwear, and hearing heavy end. Most other attachments make the front protection during operation or while adjusting or of machine the heavy end. -
Page 5: Safety And Instructional Decals
172 kg (380 lb). Other models 172 kg (380 lb) To ensure optimum performance and continued safety certification of the machine, use only genuine Toro replacement parts and accessories. Replacement decal133-8061 parts and accessories made by other manufacturers... -
Page 6: Operation
Operation Material Density Material Density (Approximate) Determine the left and right sides of the machine from Caliche 1250 kg/m (78 lb/ft the normal operating position. Clay: Natural bed 1600 kg/m (104 lb/ft Installing and Removing 1480 kg/m (93 lb/ft the Attachment 1660 kg/m (104 lb/ft With gravel, dry... -
Page 7: Transport Position
Storage Before long-term storage, wash the attachment with mild detergent and water to remove dirt and grime. Paint all scratched or bare metal surfaces. Note: Paint is available from your Authorized Service Dealer. Store the attachment in a clean, dry garage or storage area. - Page 8 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.