Toro TX525 Service Manual page 265

HYDRAULIC SYSTEM
4. Remove the rear access panel (Fig. 0835).
5. Using a 3/8" socket, remove the 3 screws securing
the right hand side support bracket to the tower.
Remove the right hand side support bracket (Fig.
0836).
6-2
Fig 0835 PICT-4505a
Fig 0836 PICT-4504
6. Mark the 2 spool valve fittings and hydraulic line nuts
with the letters A – F as follows (Fig. 0837):
A B C D
A. Hydraulic oil inlet line
B. Tilt cylinder line
C. Lift cylinder line
7. Using a 15/16" wrench, disconnect the hydraulic line
marked F from the 2 spool loader valve fitting (Fig.
0838).
Rev. 000
E
F
Fig 0837 PICT-4876a
D. Hydraulic oil return line
E. Lift cylinder line
F. Tilt cylinder line
Fig 0838 PICT-4879
TX525 Service Manual