Setting The Powered Zone 2 - Onkyo TX-SR604 Instruction Manual

Zone 2—Continued

Setting the Powered Zone 2

To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
1
Press the [RECEIVER] button fol-
RECEIVER
lowed by the [SETUP] button.
The main menu appears onscreen.
SETUP
2
Use the Up and Down [
buttons to select "8. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
3
Use the Up and Down [
buttons to select "Powered Zone
2," and use the Left and Right
[
Not Act: ZONE 2 SPEAKERS termi-
When Zone 2 is activated and turned on
(see page 81), the speakers connected
to the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURROUND BACK
SPEAKERS terminals do not (when
Zone 2 is activated but not used, the
surround back speakers work as nor-
mal).
80
]/[ ] buttons to select:
8.Hardware Setup
------------------------
a.SP Impedance :6ohms
b.PoweredZone2:NotAct
c.TV Format :Auto
d.AM Freq. Step: 9kHz
e.Remote ID :1
f.HDMI Audio Out :Off
g.SW Input Sensitivity
: 0dB
nals deactivated.
Act: ZONE 2 SPEAKERS termi-
nals activated.
4
SETUP
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
]/[ ]
]/[ ]
Press the [SETUP] button.
The setup menu closes.