Setting The Powered Zone 2/3 - Onkyo TX-NR1007B Instruction Manual

Multi Zone—Continued

Setting the Powered Zone 2/3

If you've connected your Zone 2/3 speakers to the AV
receiver, as explained in "Connecting Your Zone 2
Speakers Directly to the AV receiver" on page 124 or
"Connecting Your Zone 3 Speakers Directly to the AV
receiver" on page 126, you must set the "Powered
Zone2" or "Powered Zone3" setting to "Act" (Acti-
vated).
1
Press the [RECEIVER] button
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ]
buttons to select "2. Speaker
Setup", and then press [ENTER].
The "Speaker Setup" menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
3
Use the Up and Down [ ]/[ ]
buttons to select "1. Speaker
Settings", and then press
[ENTER].
The "Speaker Settings" menu appears.
2–1. Speaker Settings
Speaker Impedance
Speakers Type(Front)
Powered Zone2
Powered Zone3
4
5
Notes:
• Powered Zone3 cannot be used if "Speakers
Type(Front)" is set to "Bi-Amp" (see page 53).
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
6ohms
Normal
Not Act
Not Act
Use the Up and Down [ ]/[ ]
buttons to select "Powered
Zone2" or "Powered Zone3", and
use the Left and Right [ ]/[ ]
buttons to select:
Not Act:
ZONE 2/3 L/R speaker terminals
not activated (Powered Zone 2/3
disabled).
Act:
ZONE 2/3 L/R speaker terminals
activated (Powered Zone 2/3
enabled).
Press the [SETUP] button.
The setup menu closes.
127